BuildVision AIBuildVision AI
Serving Aurora, CO HVAC Contractors

HVAC Estimating Softwarefor Aurora Contractors

If you're bidding hvac in Aurora, the gap between a job that nets margin and one that doesn't usually comes down to undersizing equipment for actual load. Drop a plan set in, walk away for 15 minutes, come back to a priced bid you can defend.

What's actually being bid around Denver Metro

500+ hvac contractors chasing work in Aurora, growth tracking 15% year-over-year. Average ticket sits around $75,000, labor rates run 8% above the US benchmark, and airport work is what most hvac contractors are quoting on this week.

Airport work

Plan sets we see most: airport. Recurring scope items get pre-counted, so you spend the time on the unusual stuff instead of re-counting outlets.

Residential work

Residential jobs in Denver Metro tend to share details — once you've priced one, the AI learns your pricing assemblies and applies them to the next.

Healthcare work

For healthcare work specifically, the gotcha is usually Missing return air requirements. Flag it at takeoff.

15 minutes
Median wall-clock to a finished hvac takeoff once plans are uploaded — counting cfm requirements, pricing ductwork, and producing a quote you can send.

How BuildVision AI handles a hvac plan set

Symbol counts, measurements, and assemblies a Aurora hvac contractor would normally do by hand on a takeoff table. Same answer, faster, with a margin loaded in.

Load Calculator

Quick load estimates from square footage and plans

Duct Takeoff

AI measures duct runs and calculates materials

Equipment Sizing

Proper equipment sizing based on load calculations

Register Counter

Counts all supply and return registers

Every line item that lands on the BOM

These are the 10 hvac categories the takeoff pulls. Miss any of these on a Aurora job and the change order eats your margin before the slab is poured.

Ductwork
Registers
Grilles
Diffusers
Equipment
Refrigerant Lines
Thermostats
Dampers
Insulation
Hangers
CO Licensing

Pulling permits in Colorado: the license you actually need

Colorado skips the state-level card for hvac work — but Aurora and surrounding Denver Metro jurisdictions still pull occupational licenses, and your insurer probably wants proof of one before it writes a GL policy on you.

License Type

No statewide HVAC license; local licenses vary

Issued by Local jurisdiction

Bond & Exam

Varies by municipality

No exam required

Experience & Renewal

None at state level

Renews: N/A

Colorado does not have a statewide HVAC contractor license. Denver, Jefferson County, and other jurisdictions require local licensing. EPA 608 required for refrigerant work.

Permits, fees, and labor reality in Aurora

Numbers below come from Aurora/CO permit offices and prevailing crew rates. Load them into your bid up front so a slow plan-review doesn't turn into general-conditions overrun.

Permit Cost Range

$200–$4,000

Typical hvac permit fee in Aurora

Processing Time

3–6 weeks

Average permit approval timeline

Local Labor Rates

+8% vs national avg

vs US national average for hvac

Stuff Aurora hvac contractors ask before they sign up

Does this respect CO code, or do I have to re-cut every quantity?

CO doesn't license hvac at the state level, so the variability comes from local amendments. Quantities are correct; you adjust crew rates and local permit assumptions in the bid summary.

How do you handle manual load calculations take forever?

The model reads the plan once, counts symbols against your assembly library, and surfaces the count for review. You override anything that looks off before it hits the quote. For airport work in Aurora, the typical correction is one or two assemblies — not redoing the whole thing.

What about site conditions?

Build the local condition into your assembly defaults once, and it carries forward to every Aurora bid afterward.

Anything else specific to Colorado?

Colorado does not have a statewide HVAC contractor license. Denver, Jefferson County, and other jurisdictions require local licensing. EPA 608 required for refrigerant work.

How much does a permit add to a hvac job around here?

Plan on $200–$4,000 in Aurora, with review running 3–6 weeks. Build that into general conditions so a slow plan-check doesn't eat your overhead. Insurance and bond are separate carrying costs — Colorado also requires a Varies by municipality.

Aurora, CO

Stop losing Aurora bids to slow takeoffs

Upload a plan set, get a margin-loaded hvac quote back in 15 minutes. First bid is free — if the numbers don't hold up against your last paper takeoff, walk away.

15 minutes from plan upload to priced quote • $299/mo Pro plan • no card on the trial

HVAC Estimating Software Aurora, CO