A concrete floor slab placed directly on the prepared ground, supported by the soil below rather than by beams or walls, typically 4 inches thick or more.
A slab on grade is a concrete floor slab cast directly on the ground, supported by a compacted subgrade and granular base instead of by structural framing. It is the most common ground floor for houses, warehouses, retail buildings, and many commercial projects. Residential slabs are commonly 4 inches thick, while commercial and industrial slabs are often 5 to 8 inches or more, depending on loads such as forklifts and racking.
A typical slab-on-grade assembly includes compacted subgrade, a layer of granular base such as crushed stone, a vapor retarder (commonly 10 or 15 mil, meeting ASTM E1745), reinforcement in the form of welded wire reinforcement, rebar, or fibers, and the concrete itself, with control joints sawn or formed to manage shrinkage cracking. A monolithic slab is poured together with its thickened edge footings, while a floating slab is placed separately inside stem walls or foundation walls.
Slabs on grade appear on the foundation plan, with thickness, reinforcement, and base noted in callouts or a typical slab section. Details show thickened edges, thickened slabs under interior bearing walls, depressions for tile or showers, control joint and construction joint layouts, and slab edge insulation where required by the energy code. The specifications (Division 03 for concrete and Division 31 for earthwork) set compaction, concrete strength, finishing tolerances, and curing.
Estimators take off a slab on grade in several units at once: square feet (SF) for finishing, vapor retarder, and reinforcement; cubic yards (CY) for concrete, calculated as area times thickness in feet divided by 27, with thickened edges and footings added separately; cubic yards or tons for granular base; and linear feet (LF) for edge forms, control joints, and joint sealant. A waste factor is added to the concrete volume to cover subgrade variation and over-excavation.
Measure the slab area from the foundation plan by thickness zone, subtract any large openings or pits, and calculate concrete volume for each zone separately. Then add thickened edges and interior thickened slabs as linear feet times their cross-section, the base course volume, vapor retarder area with an allowance for laps and turn-ups, reinforcement by area or by bar list, and the control joint layout in linear feet. Do not forget slab depressions, embedded items, and the finishing labor, which is priced per square foot. BuildVision AI can produce a first pass of slab areas and edge lengths from PDF plans for the estimator to review and adjust.
Residential slabs on grade are commonly 4 inches thick. Commercial and industrial slabs are often 5 to 8 inches or thicker, depending on design loads. The structural drawings always govern the required thickness.
A monolithic slab is poured in one placement with its thickened edges acting as footings. A floating slab is placed separately, inside foundation walls or stem walls that were built first, and is not structurally tied to the perimeter foundation in the same way.
Multiply the slab length by width to get square feet, multiply by thickness in feet, and divide by 27 to get cubic yards. A 1,000 square foot slab that is 4 inches thick is 1,000 times 0.333 divided by 27, or about 12.3 cubic yards, before thickened edges and waste.
Most slabs on grade under conditioned or finished spaces are placed over a vapor retarder to limit moisture migration from the ground, which can damage flooring and adhesives. The project specifications and local code set the material and thickness.
Producing accurate slab on grade the manual way takes hours. BuildVision AI reads your drawings and generates structured takeoffs and BOQs in minutes, ready for your own pricing.
Direct from PDF plans, uploaded as one PDF or a ZIP of PDFs.
Itemized bills of quantities ready for pricing or owner submission.
Branded quotes priced with your own rates, shared as a link.
First takeoff free · No card · $299/seat/month after