In construction estimating

Rough Order of Magnitude Estimate

A rough order of magnitude (ROM) estimate is an early, low-detail cost estimate prepared with minimal design information to tell an owner whether a project is in the right financial range.

Definition

A rough order of magnitude (ROM) estimate is a preliminary cost estimate prepared at the very start of a project, when little or no design exists. Its purpose is to answer one question — is this project roughly a $1 million job or a $10 million job? — so the owner can decide whether to proceed, set an initial budget, or compare alternatives. It is built from parametric methods such as cost per square foot or cost per unit, not from a quantity takeoff.

Because it rests on so few defined inputs, a ROM estimate carries a wide accuracy range. The Project Management Institute’s PMBOK Guide describes a ROM estimate as having a range of about -25% to +75%, and AACE International’s estimate classification system places it at Class 5, the least defined level. ROM figures should always be presented as a range or with stated assumptions, never as a firm price.

How rough order of magnitude estimate is used in estimating

ROM estimates appear in feasibility studies, capital planning, and early owner conversations, often before an architect is under contract. The estimator typically multiplies an expected floor area, number of units, or number of beds by a historical cost per unit, then adjusts for location, building type, quality, and expected escalation to the construction midpoint. A design contingency is usually added to cover scope that has not been defined yet.

Contractors are also asked for ROM numbers informally by clients and design teams. A good practice is to document every assumption — area, building systems, finish level, exclusions, and the date of the pricing — because a ROM number tends to be remembered as a commitment long after the design has changed. As the design progresses, the ROM is replaced by schematic, design development, and finally construction document estimates based on real quantities.

How to prepare a ROM estimate

Start with the best available measure of size, such as gross square footage, and select comparable historical projects or published cost data for the same building type and region. Adjust for differences in quality, systems, and site conditions, escalate to the expected construction period, and add a contingency that reflects how little is known. Present the result as a range with an explicit list of inclusions and exclusions. The most common mistakes are presenting a single number without a range, using cost data from a different region or building type without adjustment, and omitting site work, soft costs, or escalation that the owner assumes are included.

Frequently asked questions

Q.How accurate is a rough order of magnitude estimate?

A ROM estimate is the least accurate type of estimate. PMI’s PMBOK Guide cites a range of roughly -25% to +75%, and AACE International classifies it as a Class 5 estimate with a similarly wide range. The actual accuracy depends on how much is known about the project.

Q.What is the difference between a ROM estimate and a detailed estimate?

A ROM estimate uses parametric measures like cost per square foot and requires almost no design. A detailed estimate is built from a full quantity takeoff of the construction documents, priced line by line with labor, material, and equipment costs, and is accurate enough to bid.

Q.When should a ROM estimate be used?

Use a ROM estimate for feasibility studies, early budgeting, comparing project options, and deciding whether to invest in design. It should not be used as a contract price or as the basis for a bid.

Q.Is a ROM estimate the same as a ballpark estimate?

In practice, yes. “Ballpark,” “conceptual,” and “ROM” are often used interchangeably for an early estimate meant to establish the general cost range of a project rather than a precise number.

BuildVision AI

Save time with AI-powered estimating

Producing accurate rough order of magnitude estimate the manual way takes hours. BuildVision AI reads your drawings and generates structured takeoffs and BOQs in minutes, ready for your own pricing.

AI takeoffs

Direct from PDF plans, uploaded as one PDF or a ZIP of PDFs.

BOQ generation

Itemized bills of quantities ready for pricing or owner submission.

Quote and bid

Branded quotes priced with your own rates, shared as a link.

First takeoff free · No card · $299/seat/month after

Rough Order of Magnitude (ROM) Estimate | Glossary