In construction estimating

Elevation Drawing

A flat, straight-on view of a vertical surface such as an exterior facade or interior wall, showing heights, materials, openings, and finishes.

Definition

An elevation drawing is an orthographic view of a vertical surface, drawn straight on as if the viewer were standing directly in front of it with no perspective. It shows the heights, materials, openings, and finishes of an exterior facade or an interior wall, complementing the floor plan, which shows the same building from above.

Exterior elevations are typically named by the direction they face (north, south, east, west) or by grid line, and show cladding materials, window and door openings, roof lines, floor-to-floor heights, and finished floor levels. Interior elevations show individual walls inside rooms — kitchens, restrooms, casework walls, and feature walls — with cabinets, fixtures, tile, mounting heights, and accessories.

How elevation drawing is used in estimating

On a typical architectural set, exterior elevations appear in their own sheet series after the floor and roof plans, and interior elevations follow later, often referenced from the floor plans with elevation tags that point to a specific wall. Elevations carry level datums (for example, first floor at 0 ft-0 in and second floor at 14 ft-0 in) and material keynotes that tie back to the specifications.

Estimators use elevations for any scope that is measured vertically: exterior cladding such as brick, siding, metal panel, or stucco in square feet net of openings; sealant and flashing in linear feet; windows and doors as each, matched to the schedules; and interior tile, wall protection, and specialty finishes in square feet. Plans give the length of a wall, but only the elevation or section gives its true height, so elevations are essential for accurate wall-area takeoffs.

How to take off from elevation drawings

Measure each elevation by material, not as a single gross area, and deduct openings consistently according to your company’s rule (many estimators deduct only openings above a set size). Check that the heights on the elevations agree with the wall sections and building sections, and watch for materials that wrap corners or return into openings, which add area that a flat elevation does not show. Cross-check window and door counts against the schedules, and remember that an elevation drawn straight on does not show the true area of a sloped or curved surface.

Frequently asked questions

Q.What is the difference between an elevation and a section?

An elevation shows the outside face of a wall or building as you would see it standing in front of it. A section shows what you would see if the building were cut through, revealing the internal construction, floor assemblies, and wall layers.

Q.What is the difference between an elevation and a floor plan?

A floor plan is a horizontal view looking down on a level of the building, showing wall lengths and room layouts. An elevation is a vertical view of a wall or facade, showing heights, openings, and materials.

Q.What are interior elevations used for?

Interior elevations show individual walls inside rooms, such as kitchen and restroom walls, with cabinets, fixtures, tile, accessories, and mounting heights. Contractors use them to install casework and fixtures in the right locations and estimators use them to measure wall finishes.

Q.Why are exterior elevations named north, south, east, and west?

Exterior elevations are commonly named for the compass direction the facade faces so that everyone on the project refers to the same wall. Some drawing sets name them by grid line instead, especially when the building is not aligned to the compass.

BuildVision AI

Save time with AI-powered estimating

Producing accurate elevation drawing the manual way takes hours. BuildVision AI reads your drawings and generates structured takeoffs and BOQs in minutes, ready for your own pricing.

AI takeoffs

Direct from PDF plans, uploaded as one PDF or a ZIP of PDFs.

BOQ generation

Itemized bills of quantities ready for pricing or owner submission.

Quote and bid

Branded quotes priced with your own rates, shared as a link.

First takeoff free · No card · $299/seat/month after

Elevation Drawing in Architecture | Glossary