Black plastic pipe made from acrylonitrile butadiene styrene, used for drain, waste, and vent (DWV) plumbing lines and joined with one-step solvent cement.
ABS pipe is a rigid black plastic pipe made from acrylonitrile butadiene styrene, used almost entirely for non-pressure drain, waste, and vent (DWV) systems. It carries wastewater from fixtures to the building drain and vents sewer gases through the roof. ABS is joined with ABS solvent cement in a single step, without a separate primer, and is manufactured to standards such as ASTM D2661 (solid wall) and ASTM F628 (cellular core).
ABS and PVC serve the same DWV role, and both are recognized by the major model plumbing codes, but local jurisdictions decide which materials are allowed. ABS is not rated for pressurized potable water lines. Common DWV sizes run from 1-1/2 inch for fixture drains up to 3 and 4 inch for building drains and stacks, with larger diameters available for mains.
On construction documents, ABS shows up in the plumbing specifications (CSI Division 22) and on the plumbing plans, riser diagrams, and isometrics, where sanitary, waste, and vent lines are drawn by size. The spec section states whether ABS, PVC, or cast iron is required and often limits plastic pipe to certain areas, such as below grade or within residential units, because of fire-rating or plenum restrictions.
Estimators take ABS pipe off in linear feet (LF), separated by diameter and by system (waste versus vent), and count fittings such as wyes, sanitary tees, elbows, and couplings as each (EA). Watch for vertical runs that only appear on riser diagrams, transition fittings where ABS meets cast iron or PVC, and fire-stopping at every rated penetration, which is a separate line item.
Start from the plumbing floor plans and measure each run by size, then add the vertical lengths from the riser diagram using floor-to-floor heights. Count fittings at every change of direction and branch connection rather than relying on a flat percentage, because DWV systems are fitting-heavy. Keep waste, vent, and below-grade pipe on separate lines so trenching and backfill can be priced against the buried runs. AI takeoff software like BuildVision AI can produce a first pass of pipe lengths and fitting counts from the PDF plans for the estimator to review and adjust.
Both are plastic DWV pipe. ABS is black and is joined with one-step ABS cement, while PVC is usually white and is typically joined with primer and PVC cement. PVC is also made in pressure-rated versions for water lines, which ABS is not. Which one a project uses usually comes down to the specification and what the local code official allows.
Yes, but not with ordinary ABS or PVC cement alone. The connection is made with a transition cement listed for joining ABS to PVC, where the local code permits it, or with a mechanical shielded coupling. Check the plumbing code adopted by the jurisdiction before assuming either method is acceptable.
No. ABS pipe is intended for drain, waste, and vent systems, which are not under pressure. Potable water supply lines use materials rated for pressure and drinking water, such as copper, PEX, CPVC, or pressure-rated PVC for some underground service lines.
ABS pipe is measured in linear feet for each diameter, with fittings counted individually. Estimators usually separate below-grade, above-grade, waste, and vent runs because labor and associated work, such as excavation or hangers, differ between them.
Producing accurate abs pipe the manual way takes hours. BuildVision AI reads your drawings and generates structured takeoffs and BOQs in minutes, ready for your own pricing.
Direct from PDF plans, uploaded as one PDF or a ZIP of PDFs.
Itemized bills of quantities ready for pricing or owner submission.
Branded quotes priced with your own rates, shared as a link.
First takeoff free · No card · $299/seat/month after