Detailed drawings prepared by a contractor, subcontractor, fabricator, or supplier that show exactly how a component will be fabricated and installed.
Shop drawings are detailed drawings prepared by a contractor, subcontractor, fabricator, or manufacturer that show exactly how a specific part of the work will be fabricated and installed. They translate the design intent shown on the architect’s and engineer’s drawings into the precise dimensions, connections, materials, and installation details the shop and field crews will build from.
Common examples include structural steel erection and detail drawings, rebar placing drawings, sheet metal ductwork layouts, fire sprinkler layouts, curtain wall and storefront details, millwork and casework drawings, and precast concrete panel drawings. Shop drawings are not part of the contract documents; they are submittals that demonstrate how the contractor intends to meet the requirements of those documents.
Shop drawings move through the submittal process defined in Division 01 of the specifications (01 33 00 Submittal Procedures in CSI MasterFormat). The subcontractor prepares them, the general contractor reviews and stamps them, and the architect or engineer reviews them for general conformance with the design and returns them marked approved, approved as noted, or revise and resubmit. Fabrication normally cannot start until the relevant shop drawings are returned, so their timing drives procurement and the schedule.
At bid time, estimators take off quantities from the design drawings, not shop drawings, because shop drawings do not exist yet. What the estimator must carry is the cost of producing them: steel detailing, rebar detailing, ductwork coordination drawings, and engineered layouts such as fire sprinkler drawings all take real hours and are usually priced as a lump sum within the trade’s scope. When shop drawings later reveal quantities or details that differ from the bid documents, that gap is often the starting point for an RFI or change order.
The most common mistake is forgetting to carry the cost of detailing and engineering at all, especially on delegated-design items like fire sprinklers, cold-formed metal framing, or curtain wall where the specification requires a licensed engineer’s stamp. Another is underestimating review cycles — a resubmittal can add weeks to procurement and push work into a more expensive season. Estimators should read the submittal requirements in each specification section, confirm which items require stamped calculations, and make sure each subcontractor bid explicitly includes shop drawings and the number of resubmittals assumed.
Construction drawings are prepared by the architect and engineers and show the design intent; they are part of the contract documents. Shop drawings are prepared by the contractor or fabricator and show how a specific component will be built and installed to meet that intent. Shop drawings are submittals, not contract documents.
Shop drawings are prepared by the subcontractor, fabricator, or supplier responsible for the work — for example, a steel fabricator’s detailer or a fire sprinkler contractor’s designer. The general contractor reviews them for coordination before forwarding them to the design team.
Generally no. Most contracts state that the design team’s review of shop drawings does not relieve the contractor of responsibility for meeting the contract documents, and that changes to the scope or price must be made through a change order rather than a shop drawing approval.
Producing accurate shop drawings the manual way takes hours. BuildVision AI reads your drawings and generates structured takeoffs and BOQs in minutes, ready for your own pricing.
Direct from PDF plans, uploaded as one PDF or a ZIP of PDFs.
Itemized bills of quantities ready for pricing or owner submission.
Branded quotes priced with your own rates, shared as a link.
First takeoff free · No card · $299/seat/month after