A steel beam with an I- or H-shaped cross section, made of two horizontal flanges joined by a vertical web, used to carry heavy loads over long spans.
An I-beam is a structural beam whose cross section looks like a capital letter I: two horizontal plates called flanges connected by a vertical plate called the web. The flanges resist most of the bending, while the web resists shear, which makes the shape very efficient at carrying heavy loads across long spans with relatively little material. I-beams support floors, roofs, and walls in commercial buildings and are also used as headers and flush beams in houses.
In US practice, "I-beam" is used loosely for two standard shapes. Wide flange beams, designated W shapes and commonly rolled to ASTM A992, have wide flanges with parallel inner faces and are by far the most common. American Standard beams, designated S shapes, have narrower flanges with tapered inner faces. Beams are named by nominal depth and weight per foot, so a W12x26 is a wide flange about 12 inches deep that weighs 26 pounds per linear foot.
I-beams appear on structural framing plans, where each member is labeled with its size, such as W16x31, and on sections and details that show connections, bearing plates, and camber. The structural general notes and the steel specification (CSI Division 05) list the material grades, connection design responsibility, fireproofing, and finish requirements.
Estimators take off each beam by size and length in linear feet, then multiply by the weight per foot from the AISC shapes tables to convert to pounds and tons, because structural steel is typically priced and fabricated by the ton. Connections, base plates, and stiffeners are counted as each or added as a percentage of main member weight based on the estimator's own historical jobs. Watch for camber, galvanizing, and fireproofing, which add cost beyond the raw tonnage.
Work floor by floor on the framing plans and list every beam by mark, size, and length measured from centerline to centerline of supports, then adjust for connection setbacks if the estimate needs that precision. Extend each line by its weight per foot to get total tons by size, and keep beams, columns, and miscellaneous steel on separate lines because shop and erection rates differ. Cross-check the total against the steel tonnage on similar past projects before pricing. AI takeoff software like BuildVision AI can give a first pass of member counts and lengths from PDF plans for the estimator to verify against the framing schedule.
They are the same family of shape. "H-beam" usually refers to a wide flange section whose flanges are about as wide as the section is deep, so it looks like an H. In US standards both are covered by wide flange W shapes, and S shapes are the narrower, tapered-flange I-beams.
The W means wide flange, the first number is the nominal depth in inches, and the second number is the weight in pounds per linear foot. A W8x10 is roughly 8 inches deep and weighs 10 pounds per foot. Actual depth and flange width are listed in the AISC Steel Construction Manual.
In everyday use, yes. Contractors call wide flange beams I-beams, but technically the American Standard S shape is the classic I-beam with tapered flanges, while the W shape has parallel flanges and is the shape most commonly specified today.
Estimators list each member by size and length, convert to weight using pounds per foot, and total the steel in tons. Fabrication, erection, connections, coatings, and fireproofing are then priced against that tonnage or as separate line items.
Producing accurate i-beam the manual way takes hours. BuildVision AI reads your drawings and generates structured takeoffs and BOQs in minutes, ready for your own pricing.
Direct from PDF plans, uploaded as one PDF or a ZIP of PDFs.
Itemized bills of quantities ready for pricing or owner submission.
Branded quotes priced with your own rates, shared as a link.
First takeoff free · No card · $299/seat/month after